Injap Pintu Seal Seat Resilient

1. PengenalanInjap Pintu Seal Seat Resilient

Injap Pintu Seal Seat Resilient are also called lifting stem gate valves, also called rising stem gate valves. Usually there is a trapezoidal thread on the lifting rod, through the nut on the top of the valve and the guide groove on the valve body, the rotary motion is changed into linear motion, that is, the operating torque is changed into operating thrust. The opening and closing part of Injap Pintu Seal Seat Resilient is a gate. The movement direction of the gate is perpendicular to the direction of the fluid. It can only be fully opened and closed, but cannot be adjusted or throttled. The Injap Pintu Seal Seat Resilient produced by Milestone Valve Company have stable performance and are used in various fields such as petroleum, chemical industry, and water conservancy.

2. Parameter TeknikalInjap Pintu Seal Seat Resilient

3.Key points of operation of Injap Pintu Seal Seat Resilient:

1) The opening and closing direction of Injap Pintu Seal Seat Resilient should always be closed clockwise.
2. Pneumatic valves in the Injap Pintu Seal Seat Resilient pipe network are often opened and closed manually, and the number of opening and closing revolutions should not be too much, that is, large-diameter valves should also be within 200-600 revolutions.
3) Injap Pintu Seal Seat Resilient In order to facilitate the opening and closing operation of one person, the larger opening and closing torque should be 240N-m under the pressure of the pipeline.
4) The opening and closing end of Injap Pintu Seal Seat Resilient should be a square tenon, with standardized dimensions, and face the ground so that people can directly operate it from the ground. Valves with roulette are not suitable for underground pipe networks.

4. Pembungkusan dan Penghantaran

5. Soalan Lazim

1. Bolehkah saya mempunyai pesanan sampel untuk injap?
J: Ya, kami mengalu-alukan pesanan sampel untuk menguji dan memeriksa kualiti, Sampel campuran diterima.
2. Adakah anda mempunyai had MOQ untuk pesanan injap?
A: MOQ rendah, 1 PC untuk pemeriksaan sampel tersedia.
3. Bolehkah anda menawarkan perkhidmatan OEM?
J: Ya, OEM tersedia.
4. Bagaimana dengan pembayaran?
J: Kami biasanya menerima deposit 30%, dan baki akan dibayar sebelum penghantaran. L7C OK
5. Berapakah masa penghantaran injap rama-rama anda?
J: Untuk kebanyakan ukuran, DN50-DN600, kami mempunyai stok bahagian injap, mungkin untuk dihantar dalam 1-3 minggu, ke pelabuhan laut Tianjin terdekat.
6. Adakah jaminan produk anda?
J: Kami biasanya menawarkan jaminan selama 12 bulan dalam perkhidmatan atau 18 bulan sejak tarikh penghantaran.
7. Apakah standardisasi produk anda?
J: GB / T12238-2008, JBfT 8527-1997, API 609, EN 593-1998, DIN 85003-3-1997

6. Maklumat Hubungi